Videos Page

Photos

Fasteners

Parts List

Replications by Others

Contact us

Links to other sites

Drawings

Knowing that most people doesn't have or don't even have access to an oscilloscope, I decided to do some tests using plain multi-meters. While doing these tests, it became very clear to me how it is near impossible to measure the input to The GAP Generator. I explain this in both the video and in the pdf file below. There is more detail in the pdf file. I have always known the amp reading on the power supply reads way higher than what The GAP Generator will operate on. Testing with regular multi-meters, this really stood out more, made it easier to see, and determine the reason. That reason being, no matter where I check the input, it includes the output as well. This is because the input and output are on the same circuit. I know, to most people, this will all sound strange, but, it gets even more strange. Just watch the video and read the pdf file.

The tests in the video and pdf file were done using a 5 amp fast acting fuse. I've since discovered The GAP Generator, with the load described in the tests will operate on a 4.75 amp fast acting fuse. Remember this while examining the test results.

Let me know what you think.

Art

A Truth About Electric Motors.

They don't operate on electricity. They run on magnetism. The magnetism they run on is produced by electricity.

Like a battery stores electricity, a permanent magnet stores magnetism. Unlike a battery, it's possible the magnet may never run down.